How To: Change IP address

In to Hacking profession its necessary to hide your identity. Many people do not understand the value of secrecy and get caught. So its really important for hackers survive without being caught. There are many ways to survive as an hacker but the most important is to change your ip address. Anybody can easily track you and find you. Today i will tell you How to: Change IP address.

What is an IP address ? 

Every device connected to the public Internet is assigned a unique number known as an Internet Protocol (IP) address. IP addresses consist of four numbers separated by periods (also called a ‘dotted-quad’) and look something like 127.0.0.1.

Since these numbers are usually assigned to internet service providers within region-based blocks, an IP address can often be used to identify the region or country from which a computer is connecting to the Internet. An IP address can sometimes be used to show the user’s general location.

How to : Change ip address

“How do I change my IP address?” and “Can I change my IP address?” are probably the most commonly asked questions

It is a pretty basic tip but it is really important for newbies .

Here are simple steps to change your ip-address:

1. Click on “Start” in the bottom left hand corner of screen

2. Click on “Run”

3. Type in “command” and hit ok

You should now be at an MSDOS prompt screen.

4. Type “ipconfig /release” just like that, and hit “enter”

5. Type “exit” and leave the prompt

6. Right-click on “Network Places” or “My Network Places” on your desktop.

7. Click on “properties”

You should now be on a screen with something titled “Local Area Connection”, or
something close to that, and, if you have a network hooked up, all of your other
networks.

8. Right click on “Local Area Connection” and click “properties”

9. Double-click on the “Internet Protocol (TCP/IP)” from the list under the”General” tab

10. Click on “Use the following IP address” under the “General” tab

11. Create an IP address (It doesn’t matter what it is. I just type 1 and 2
until i fill the area up).

12. Press “Tab” and it should automatically fill in the “Subnet Mask” section
with default numbers.

13. Hit the “Ok” button here

14. Hit the “Ok” button again

You should now be back to the “Local Area Connection” screen.

15. Right-click back on “Local Area Connection” and go to properties again.

16. Go back to the “TCP/IP” settings

17. This time, select “Obtain an IP address automatically”
tongue.gif

18. Hit “Ok”

19. Hit “Ok” again

20. You now have a new IP address